News

Contact

EMAILE-mail: sales@lybga.cn
 
MobileTel: +86-755-82976821

MobileFax: +86-755-36815936

Location: Home > News > Industry News
Industry News

How to Select a BGA Rework Station?

How to Select a BGA Rework Station?

 

1.Introduction of BGA

Defects are caused by many reasons during soldering SMD rework components as empty soldering,

short circuit and others, so repair is necessary. The rework process is simple for common SMD, resistor,

capacitor, SOIC, SOJ, PLCC and others. With small alignment are more and more in electronic products,

lots of BGA, CSP, QFP and others are more and more, so BGA rework stations become good helpers for

operators.

 

2.How to select a suitable BGA rework station?

Main differences of rework stations are heat source and heat mode. Take example only upper heat or

upper and lower both heating,  some can set temperature curve. Considering protecting components, 

the upper and lower both heating system are better. To prevent PCB warping during repairing,

preheat function in the rework system is better. PCB fix, BGA position and others are important

consideration.

 

3.Rework process

1)BGA disassemble Remove BGA chip with rework system and clean solder residue on PCB

with solder iron to make solder pad flat. Clean and remove flux residue with special cleaner.

 

2)BGA dry Please check all BGA chips dry or damp.  Put damp BGA components into dry box to dry.

 

3)Print solder paste Print solder paste on disassemble location before soldering BGA.  Small and

special BGA stencil is necessary because there are other components on the board. Thickness and

size of stencils are decided by BGA ball diameter and distance.

 

4)Mount BGA chips Set rework program and put dry BGA into preparation location;

rework system will take it automatically and then place it into soldering location.

 

5)Soldering process Set tempeature profile according BGA size, PCB thickness and others, 

then BGA rework station will finish the soldering process.

 

 

 

 

 

Hits:  【Printing